Quality Heat Pump Service in Kingston

Quality Heat Pump Repair and Replacement in Kingston

Not only can an electric heat pump heat your home in Kingston, it can cool it too. When compared to standard heating systems—like a gas furnace—you’ll also likely have a reduced electrical bill.

Heat pumps accompany an air handler, which circulates air throughout your home. While an air handler might look like a furnace, it doesn’t produce heat through fuel combustion. However, some air handler models may have secondary electric heating or cooling parts to help out the heat pump.

When you need heat pump service or heat pump repair, contact Kingston Home Services by Enercare. We can work on any model of heat pump. Our technicians are TSSA-certified, which means they are among the top in the HVAC industry when it comes to heating and cooling.

And like all our other work, our services for heat pump systems are backed by a worry free guarantee.

Get a free quote
Poor Maintenance Can Cost You
A badly maintained system can cost you. On average, an uncared-for heat pump can consume 10 to 25 percent more energy, according to the U.S. Department of Energy. It’s also more likely to malfunction or fail prematurely.

When your HVAC system isn’t delivering the best home heating or isn’t working in a reliable manner, try our troubleshooting list below.

No heat. Check your thermostat is set to “on” and “heat.” Next, make sure a circuit breaker hasn’t tripped. Recently put in a new thermostat? Make sure it’s a model made for heat pumps and wired accurately.

Insufficient heat. Dirty filters, fan and coils can limit airflow and wreck your system. Put in a new filter once a month, clean the unit’s coils and fan, and remove yard debris that may have accumulated around it. Your system may also have blocked air ducts, faulty valves or poor refrigeration flow.

Cold air instead of heat. Air from a heat pump won’t be as toasty as a forced air furnace. But if the air still seems too chilly, set the thermostat to emergency heat and at least 5 degrees above the inside temperature. If you get warm air, there may be a problem with your outdoor unit. Cold air means there’s likely an issue with your thermostat or air handler. Your system may have also gone into defrost mode to stop it from icing up. If you see frost or ice on the outdoor coil, your unit may have a defective defroster timer or control module, or it could need refrigerant.

Heat pump turns on and off frequently. Replace your air filter and then check your thermostat, because it may need to be reset or need new batteries. If it’s cold and your system is working continuously, the thermostat may be set too high. Also, some heat pumps have trouble heating around 25 to 30 degrees Fahrenheit.

Rattling, grinding or squealing noises. If you hear rattling, try tightening the cover panels. If you hear grinding or squealing, switch off your system and get in touch with Kingston Home Services by Enercare. This could signal a serious problem.
Should I Repair or Replace My Heat Pump?
When you’re faced with an expensive repair for your heat pump, it may be time to upgrade it.

Your system may need to be replaced when it:

Isn’t providing consistent heating and cooling

Needs consistent repairs

Is increasing utility bills, even though you haven’t raised or lowered thermostat settings

Is more than 10 years old

When it comes to heat pump replacement or heat pump installation, Kingston Home Services by Enercare can help you find and install an energy-efficient model that’s right for your home. We can also help figure out whether your air handler needs to be replaced too.

You can rely on a clean installation and a thorough system check before we leave. This makes sure your new system is heating and cooling properly and that you know how to use it.